Schluter Systems LIPROTEC-EASY Mode D'emploi page 55

4. Optional: Connect the cable to the Bluetooth receiver or distributor.
> All plug connections between the power supply and the connected system compo-
nents are connected up to the sealing membrane.
5. Embed the mounting profile in the tile adhesive. In doing so, guide the white connector of
the cable out of the cavity wall socket from behind and feed it through the cable opening
into the profile.
6. Connect the connection cable of the LED tube to the white connector of the cable.
> The LED tube can be inserted in the mounting profile. Before doing so, it is advisable
to test the function of the LED tube.
Inserting the LED tubes
Personnel
Protective equipment
LED tubes must be pressed into a mounting profile along their full length. The plug connec-
tion between the LED tube and power supply, receiver, cable or distributor must already
have been established to this end. The function should be tested before the LED tube is fully
inserted in the intended mounting profile.
1. Ensure that the LED tube is connected to the intended connection cables.
2. Ensure that the power supply is plugged in.
3. Switch on the W-LED tube via a switchable socket or switch on the RGB+W-LED mod-
ules as described » "Operating the RGB+W-LED modules" on page 59 .
4. With regard to RGB+W LED tubes, test whether the LED tube lights up in colour when
Favorites are changed.
> W-LED tubes light up continuously if the switchable socket is switched on.
RGB+W-LED tubes light up continuously and can be switched to colour using the
remote control or a mobile device. The LED tube can now be inserted in the mounting
profile.
5. To install the LED tubes, first unplug the power supply from the power socket again.
6. Place the LED tube with the end without the connection cable flush with the end of the
mounting profile and press it in completely.
7. Gradually press the LED tube lengthwise into the mounting profile.
8. Push the connection cable slightly into the cavity wall socket with sealing collar.
9. Carefully press in the LED tube completely.
> The full length of the LED tube is fully seated in the mounting profile. The connection
cable is recessed in the cavity wall socket with sealing collar.
10. Repeat steps 1 – 9 for all LED tubes that are to be installed.
11. Ensure that all LED tubes are inserted as described.
12. Ensure that all components are properly connected.
> All components are installed and connected as intended. The mains cable of the
power supply can be plugged in.
13. Plug the mains cable of the power supply into the intended socket.
> All LED modules are supplied with voltage and can be switched on.
58
Tiler
Protective gloves