Ayce GENERATOR 5500 W Manuel D'utilisation page 53

OPERATION
NOTE: The generator has been shipped without engine oil. fill with oil or it will not start.
1. Filling the Engine Oil (Fig.11)
SAE 10W-30 is recommended for general, all temperature use. Other viscosities shown in the
chart may be used when the average temperature in your area is within the indicated range.
- Remove the oil filler plug (9) and wipe the dipstick clean.
- Check the oil level by inserting the dipstick into the filler neck without screwing it in
- If the level is low, fill to the upper limit of the oil filler neck with the recommended oil.
CAUTION! Carefully pour in engine oil. Avoid spilling!
fig.11
2. Filling the fuel
You must fill the fuel before start the engine.
- Open the fuel cap(2) (fig.12)
- Fill in fuel to the fuel tank,do not higher than the warning line of the fuel tank.
- Close the fuel cap(2)
fig.12
3. Start the engine
NOTE: Do not connect the electric load or equipment before starting the engine.
MANUAL START
- Do not connect the power tool before starting the motor.
- Open the petrol cock (24) by turning it down.
- Insert the starter key(31) to ON/OFF switch (3),and turn to position "
- Move the choke lever (23) to position IØI.
- Start the engine with the grip of pull cord (26) by pulling the handle forcefully. If the
engine does not start, pull the handle again.
- Push the choke lever (23) back again after the engine has started.
IMPORTANT !
When starting with the pull cord, the motor may recoil suddenly as it starts up,
resulting in hand injuries. Wear protective gloves when starting the equipment.
WARNING: Once the generator has started, release the starting handle slowly
to avoid injury/damage as it whips back.
ELECTRIC START
- Check the battery voltage. The voltage should be not less than 12V.
- Do not connect the power tool before starting the motor.
- Open the petrol cock (24) by turning it down.
- Insert the starter key(31) to ON/OFF switch (3),and turn to position "
- Move the choke lever (23) to position IØI.
- Turn the starter key(31) to the "
- Push the choke lever (23) back again after the engine has started.
4. Connecting Electric Devices
- Ensure that electrical equipment is switched off before connecting to the generator.
IMPORTANT :
- These sockets may be loaded continuously (5.0kw) and temporarily (5.5kw).
- Do not connect the generator to the domestic power network as this may result in
damage to the generator itself or to other electrical appliances in your home. Note:
Some electrical appliances (power jigsaws, drills, etc.) may have a higher level of power
consumption when used in difficult conditions.
CAUTION!
• Be sure the total load is within generator rated output.
• Be sure the socket load current is within socket rated current.
".
".
" position until the motor has started.
101 | 102
GB