Before You Begin - GE IM-4D Manuel D'utilisation Et D'installation

ICEMAKER INSTALLATION INSTRUCTIONS U V OR W
Are these the right instructions for your model? Follow the Installation Instructions indicated by the

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.
WARNING
•
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding. Failure
to follow these instructions can result in
electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
SELECT FILL TUBE FOR YOUR
1
REFRIGERATOR
Which fill tube should you use?
There is a label on the back of the refrigerator that will
tell you which to use: U V or W
The fill tube you use will depend on the model and size
of your refrigerator.
For letter U :
Use long fill tube assembly #12 and cut off 1/2" of
length from the tip of the fill tube. This will ensure the
correct length fill tube for your model. This will provide
proper water flow into your fill cup and icemaker. It will
prevent the fill tube from freezing up with water and
ice.
Installation Instructions
To eliminate the
Sharp knife
Pliers
Cut 1/2" Cut 1/2"
For letter V :
It is important to use the correct fill tube assembly
because the length is critical to the performance of
your icemaker. It is also critical to prevent any leaking
from the fill tube into the freezer itself.
• Open the fresh food door and locate the label in the
upper left corner of the compartment.
• Find the model number in bold listed under
MODEL NO.
• Match the two digit number in the model number
to the fill tube number in the table below. NOTE: The
desired number starts at the fourth character.
Model Number
GENERAL ELECTRIC COMPANY
APPLIANCE PARK LOUISVILLE, KY 40225
MODEL NO.
www.GEAppliances.com
GTH18GBDCRWW
LISTED HOSEHOLD REFRIGERATOR/FREEZER
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
For letter W :
Use short fill tube assembly #11 and cut off 1" of length
from the tip of the fill tube. This will ensure the correct
length fill tube for your model. This will provide proper
water flow into your fill cup and icemaker. It will prevent
the fill tube from freezing up with water and ice.
REPOSITION FREEZER SHELF
2
• Make sure the freezer shelf is in the lowest position.
9
Model
Number Tube
12 #
SERIAL NO.
FZ743041 15 #
182A
16 #
IIIIIIIIIII
IIIIIIII
IIIIII
18 #
21 #
Cut 1"
Fill
12
11
11
12
12