GE IM-4D Manuel D'utilisation Et D'installation page 17

ATTACH THE WATER VALVE TO THE
4
MACHINE COMPARTMENT
• Locate the female connector plug. Plug the female
connector onto the male terminals on the water
valve. Either wire can go on either terminal.
• Fasten the water valve to the cabinet by driving the
hex-head screw (9) from the kit through the hole
cabinet.
9
INSTALL WATER LINE CLAMP
5
Attach the water line clamp (6) (strain relief) from the
•
kit to the refrigerator. With the clamp directly in line
with the water valve, drive the screw (5) from the kit
through the clamp at the indent into the back of the
cabinet.
5
The metal clamp is for the house water line (see
•
Water Line Installation Instructions). It is not to be
used for the tubing from the water valve up to the
icemaker.
Installation Instructions
6
17
ROUTE AND ATTACH THE PLASTIC
6
WATER LINE
Fasten the plastic water line to the back of the
•
cabinet with adhesive-backed fasteners (4).
WATER VALVE INSTALLED
7
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water line
installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
8
Reinstall the compressor compartment access
cover. This requires using the screws you removed
previously to reattach the cover to the back of the
refrigerator case. This must be reinstalled for your
refrigerator to function properly.
4
Adhesive-backed fastener
for plastic water line