Installation Safety - Samsung NX58H9950W Série Manuel Utilisateur

INSTALLATION SAFETY

WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, obey the
following precautions.
• Have your range installed and properly grounded by a
qualified installer, in accordance with the installation
instructions. Any adjustment and service should be
performed only by qualified gas range installers or
service technicians.
Do not attempt to service, modify, or replace your
•
range or any part of your range unless it is specifically
recommended in this manual. All other service should
be referred to a qualified technician.
Always use new flexible connectors when installing a gas appliance. Do not use old flexible
•
connectors.
Make sure the anti-tip device is properly installed on the range. See the installation instructions
•
for more information.
Due to the size and weight of the range, have two or more people move the range.
•
Remove all tape and packaging materials.
•
Remove all accessories from the cooktop, oven, and/or lower drawer. Grates and griddles are
•
heavy. Use caution when handling them.
Make sure no parts came loose during shipping. Do not install in an area exposed to dripping
•
water or outside weather conditions.
Make sure your range is correctly installed and adjusted by a qualified service technician or
•
installer for the type of gas (natural or LP) you will use. For your range to utilize LP gas, the installer
must replace the 5 surface burner orifices and 2 oven orifices with the provided LP orifice set, and
reverse the GPR adapter. These adjustments must be made by a qualified service technician in
accordance with the manufacturer's instructions and all codes and requirements of the authority
having jurisdiction. The qualified agency performing this work assumes the gas conversion
responsibility.
• Installation of this range must conform with local codes or, in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must
conform with the current Natural Gas Installation Code, CAN/CGA-B149.1, or the current Propane
Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range has been
design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian Gas Association
according to CAN/CGA-1.1, latest edition.
English - 9