Operation; Synchronising Transmitter / Receiver; Setting The Signal Type - SilverCrest HG01041A Instructions D'utilisation Et Consignes De Sécurité

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
Press the synchronisation button
Press the chime button
programmed audible signal sounds and the signal indicator
ceases to illuminate.
If the receiver does not react as described, press the synchronisation
button again to switch off the synchronisation function and repeat
2
the synchronisation process.
The transmitter indicates the transmission of the signal to the receiver by
the signal indicator

Setting the signal type

The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
Using the signal type selector button
is to be indicated optically or acoustically or both optically and
acoustically.
; the signal indicator
12
flashing briefly.
10
.
2
1
, select whether the signal
5
flashes red. The
1
GB/IE/NI 13