Replacing The Battery; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts - EINHELL RT-SC 570 L Mode D'emploi D'origine

an exact guide for the cut. You can additionally ad-
just the laser with the screw (47). To do so, undo
the screw (47) by a few turns. The laser (45) can
now be moved and adjusted vertically and hori-
zontally on the adapter (48). Tighten screw (47)
again when you are satisfi ed with the adjustment.
6.6.2 Use as a laser level unit (Fig. 17-20)
Remove the screw (47). The laser (45) can now
be taken off the adapter (48) and used as an ex-
ternal laser level unit. The laser (45) is equipped
with two spirit levels (49) and can therefore be
adjusted both horizontally and vertically. The base
plate (50) of the laser is magnetic, enabling it to
be secured on suitable surfaces.
See Figures 19 and 20 for two examples of use.

6.6.3 Replacing the battery

Unscrew the 4 screws (51) and remove the base
plate (50). Take out the old batteries and replace
with new ones. Then screw the base plate (50)
back on.

7. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Remove dust and dirt from the machine at
regular intervals. Cleaning is best carried out
with a rag or brush.
•
Never use caustic agents to clean plastic
parts.
•
The trough (3) and the cooling water pump
(13) must be cleaned at regular intervals or
proper cooling of the diamond cutting wheel
(2) will not be guaranteed.
8.2 Maintenance
Lubricate all moving parts at regular intervals.
8.3 Transport
•
The coolant must be drained completely be-
fore transport.
Anl_RT_SC_570_L_SPK1.indb 21 Anl_RT_SC_570_L_SPK1.indb 21
GB
•
Do not lift the machine by any of the safety
devices.

8.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 21 -
01.10.12 14:10 01.10.12 14:10