Helo T1 Manuel Du Produit page 26

User and installation manual Helo-T1
First start-up or reset.
Select region
The following submenus are found under the menu.
All selections must be confirmed by pressing OK.
- Select the region where the controller is used.
- Europe, time and temperature settings according to European regulations.
- USA, settings according to American regulations.
- Other regions.
- Select the control panel language from the language menu.
- Select control panel usage, sauna or steam bath.
Select sauna and press OK.
Set the bathing time between 0 and 6 hours by pressing
the arrow key and confirm by pressing OK.
Enter the time into the control panel and confirm by
pressing OK.
Settings
The following submenus are found under the menu.
All selections must be confirmed by pressing OK.
- Set time. Time setting.
- Language. You can select the language from a menu.
- Display. Setting the display to sleep, time setting 3–60 s.
- Automatic key lock. Locks the buttons after 15–60 seconds, on/off.
- Vibration. Vibration function of the controller on/off.
- Service. Enter the PIN code to access the service menu.
The service PIN code is 124.
Service
The following submenus are found under the menu.
All selections must be confirmed by pressing OK.
- Bathing time limit. Time setting 0–6 hours.
- Temperature limit. Temperature setting 20–110 .
- °C or °F. Alternative temperature display.
- 24 or 12 hours. Alternative time display.
- Light button. Lighting controls, continuous or momentary.
Continuous, the lights are always on when the sauna heater is on.
Momentary, lights are only on when the light button is pressed.
- Reset PIN code 421.
- Test. In case of service or error, different relay
outputs can be tested and verified.
PIN code 666.
Select region
Europe
USA
Other region
OK
Settings
Set the time.
Language
Display
Automatic key lock
Vibration
Service
OK
Service
Bathing time limit
Temperature limit
OC or OF
24 or 12 hours
Light button
Reset
Test
OK
5