Helo T1 Manuel Du Produit page 23

User and installation manual Helo-T1
Contents
1. General
1.1 Checks to be carried out before taking a sauna bath
1.2 Control panel overview
1.3 Installing the control panel
2. Control panel
2.1 Switch diagram
2.2 Sauna heater installation principle
2.3 Remote start On/Off push button
3. ROHS
4. Warranty policy
1. General
1.1 Checks to be carried out before taking a sauna bath
1. The sauna room must be suitable for taking a sauna bath.
2. The door and the window must be closed.
3. The sauna heater must be topped with stones that comply with the manufacturer's recommendations, the
heating elements must be covered with stones, and the stones must be piled sparsely.
4. A pleasant, smooth sauna bath temperature is about 70 °C.
For additional information about enjoying a sauna bath, please visit our website at
NOTE! Structural clay tiles are not allowed.
1.2 Control panel overview
NOTE!
The control panel and connected sauna heater are designed for domestic use.
The control panel is meant to be installed outside the actual sauna room. Enclosure class IP X4.
The main switch for the sauna heater is located at the foot of the sauna heater or in the contactor case. (For
more specific instructions, see the user manual for the contactor case.)
Users should not sit in a sauna for private more than 6 hours. For facility use more than 12 hours
Temperature adjustment 20–110 °C.
Pre-set time 0–24 hours.
The control panel fits the following sauna heater models:
- 1118 - ... - 040518
- 1118 - ... - 040518
- 1118 - ... - 040518
- 1712 - ... - 040518
(LT- ... - DET) (Rocher DET)
(LT- ... - DET) (Helo Ring DET)
(LT- ... - DET) (Helo Cava/Cava Roxx DET)
(SM- ... - DET) (Helo Fonda DET)
2
2
2
3
4
6
7
8
9
10
www.helo.fi
2