walser 16773 Mode D'emploi page 22

4. Insert a new glass tube fuse (F5AL250V) onto the spring
5. Place the plug tip back on top of the new fuse.
6. Turn the screw cap clockwise to the 12V connector
7. Storage
- Allow the heated seat pad to cool completely.
- Store the heated seat pad in a clean, dry place.
- Keep the heated seat pad out of reach for children.
- Avoid that the heated seat pad is kinked during storage by heavy objects
being placed on it.
- Do not weigh down the heated seat pad with heavy objects.
8. Troubleshooting
For faults not listed here, please contact the manufacturer.
Fault
The heated
seat pad is not
functioning.
The ignition is
switched on but
the heated seat
pad does not
work.
22
Possible cause
The 12V connector is
not plugged into the
12V vehicle power
connector.
There is no voltage at
the 12V vehicle power
socket.
The 12V electrical pow-
er socket fitting is dirty.
The contact is therefore
interrupted
The fuse of the 12V
plug has blown.
The vehicle fuse has
blown
Rectification
Plug the 12V plug into the 12V
vehicle power socket correctly.
In many vehicles, the ignition
must be turned on for the 12V
vehicle power socket to be live.
Clean the 12V vehicle power
socket properly.
Replace the fuse of the 12V
plug, see section Maintenance.
Replace the vehicle fuse for
the 12V vehicle power connec-
tor. Please refer to the hand-
book for your vehicle.
.
8