Assa Abloy KEY Safe Mode D'emploi page 14

Using the pencil mark the
position of the screw holes
to be drilled.
Instruction Manual
Wall Mounting your lock
5. NOTE: You will require a X-head/Pozi screwdriver, pencil,
a spirit level, drill bit (7mm), a drill and a hammer.
1. Open the Front door.
2. Position the Key Store in the desired mounting
position.
3. Use a spirit level to check that your Key Store is level.
4. Mark the position of the screw holes on the desired
surface with your pencil (Fig. 5).
5. Remove your Key Store.
6. Drill marked holes to a depth of 38mm.
Fig. 5
7. Use hammer to fit wall plug (if necessary).
8. Mount your Key Store, insert and tighten screws.
9. Close the storage compartment.
Notes:
6. 1. You can change the combination at any time.
2. We suggest that you mount your Key Store in a
discrete location away from direct view, such as
porches, garage, out of direct eye line.
14