Cleaning And Maintenance; Electrical Connection; Disposal And Recycling; Storage - Scheppach BG200AL Traduction Du Manuel D'origine

Using the grinding wheel dresser
The grinding wheel dresser is a tool for straightening of
grinding wheels.
• Press lightly against grinding wheel – without cre-
ating sparks. Move the dresser sideways over the
entire width of wheel.
m Attention! Always wear safety goggles.

9. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
• We recommend that you clean the device immedi-
ately each time you have finished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device. The ingress of water into an electric tool in-
creases the risk of an electric shock.
Maintenance
There are no parts inside the equipment which require
additional maintenance.

10. Electrical connection

The installed electric motor is factory connected ready
for operation. The connection meets the applicable VDE
and DlN regulations.
The connection made by the customer as well as any ex-
tension cables used must comply with all relevant regu-
lations.
Connection and repair work on the elctric equipment
must be carried out by a qualified technician only.
MPORTANT NOTE
The motor rating is S 1. This means that when overload-
ed it switches off automatically. After a cooling period
(can vary) you may switch it on again.
INITIAL OPERATION
Before initial operation regard the following points:
• Turn machine on with the main switch. Wait until grind-
ing wheel has reached its operational speed before
starting to work.
• Press the work piece firmly to the work rest and move
it from one side to the other slowly and constantly on
the grinding wheel.
• Grinding may slow down the wheels. Reduce pressure
on the work piece until the wheel regain their speed.
IMPORTANT NOTE:
• Hold on to small work pieces with a pair of pliers or
similar tool.
• Never grind on the side of the wheels!
• As most materials gain heat while being grinded
please be careful with the work piece.

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Never place de-
fective equipment in your household refuse The equip-
ment should be taken to a suitable collection center for
proper disposal. If you do not know the whereabouts
of such a collection point, you should ask in your local
council offices.

12. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C. Store the electric tool in its original packag-
ing.
GB 19