Replacing The Filters - Black & Decker HLVA325B Mode D'emploi

English
Fig. I
For a more thorough cleaning (Fig. J, K)
• Figure h - Press the dust bowl release button
handle and remove the dust bowl.
• Remove filter 8 from within the bowl.
Fig. J
• Shake or lightly brush any loose dust off filter.
nOTE: The brush on the nozzle can be used to remove dirt
on the pleated filter.
• The dust bowl 3 and filter can be washed in warm soapy
water. Allow to dry before placing back into the vac.
Fig. K
3
• Place filter back into the bowl pressing firmly to ensure
a secure fit.
• To replace dust bowl, place it back onto the handle until it
"clicks" firmly into position.
iMPORTAnT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
• It is very important that the filter is correctly in position
before use.
4
3
on the
2
8
Nozzle / Accessories (Fig. M–O)
Figure M - A crevice tool
•
can be extended as shown in Figure M by pulling the
extension piece until it locks into position.
Fig. M
4
Figure n - A brush accessory
•
and can be flipped upwards for use.
Fig. N
5
Scented filter
BEFORE FIRST USE - remove bag from the scented pre-filter.
Reassemble per instructions above.
When the vacuum is turned on, the plastic scented filter will
emit an aroma to freshen the air.
WARNING:
- Causes mild skin irritation
- Toxic to aquatic life
- Harmful to aquatic life with long lasting effects.
- Dispose of contents/ containers to an approved
waste disposal plant.
nOTE: When the plastic scented filter no longer lets off
the aroma, it can be an indication that the filter needs to be
replaced. See below for information on replacement filters.

Replacing the filters

The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
4 is built into the nozzle and
5 is built into the nozzle