Low Battery Indicator - Black & Decker BDCS36G Mode D'emploi

The charger may hum and become warm
while charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at ambi-
ent temperatures below 10 °C or above 40
°C. Recommended charging temperature:
approx. 24 °C.

Low battery indicator

When the battery charge becomes low the
LED work light will begin to lash.
u
The LED Flash will last 5 seconds during
Low voltage --- --- --- at this pattern..
Warning! Do not continue using the product
with its batteries in a depleted condition.
Recharge discharged batteries promptly..
High temperature indicator
When the circuit operating temperature
becomes too high the LED work light will
begin to lash.
u
The LED Flash will last 5 seconds during
circuit high temperature ---- -- ---- -- ---- at
this pattern. Allow the unit to cool down
to an optimal operating temperature of
approximately 24°C.
Setting the initial starting point (ig. D)
u
Grasp the screwdriver as shown in igure
D.
u
Press and hold in the motion control
activator (1) on the back of the tool with
the palm of your hand.
(Original instructions)
u
When the LED work light (4) illuminates
the tool is ready for use.
u
To reset initial starting point irst release
the motion control activator (1). Move tool
to new position, then press and hold in the
motion control activator (1) on the back of
the tool with the palm of your hand..
Operating in the forward direction
(ig. E)
u
Set the initial starting point.
u
Rotate the tool clockwise and the screw-
driver will activate in the forward direction.
Note: The speed of the tool is determined by
the amount of rotation. .
Small rotation = slower speed.
Large rotation = Higher speed.
Operating in the reverse direction
(ig. F)
u
Set the initial starting point.
u
Rotate the tool anti-clockwise and the
screwdriver will activate in the reverse
direction.
Note: The speed of the tool is determined by
the amount of rotation. .
Small rotation = slower speed.
Large rotation = Higher speed.
LED work light
The LED work light (4) is activated automati-
cally when the motion control activator (1) is
depressed.
ENGLISH
9