Bialetti GIOIA CF90 Instructions D'emploi page 51

Make sure the machines does not contain any capsule. If needed,
D)
open and close the lever (7).
Position a suitable cup on the apposite rack and start the cleaning
E)
mode pressing the espresso coff ee push button (5) and the long
coff ee one (6) at the same time for 5 secs.
DURING CLEANING MODE, FOR ABOUT ONE MINUTE,
THE MACHINE DISPENSES WATER INTERMITTENTLY IN
ORDER TO CLEAN AND RINSE THE INNER CIRCUITS OF
THE MACHINE DEEPLY. AFTER ONE MINUTE, DISPENSING
IS CONTINUOUS AGAIN. DURING THIS CYCLE, THE
LIGHTS OF THE TWO POUR PUSH BUTTONS WILL BLINK
IN GREEN QUICKLY.
Stop the cleaning mode by pressing one of the two pour push buttons,
F)
when water reaches about half of the tank capacity.
Let the descaling agent act for aprox.ly 15-20 minutes with the
G)
machine off .
Switch the machine on and carry out again the operations described
H)
in point E) until the tank is completely empty.
Leave the machine off for approx.ly 5 minutes.
I)
Remove the tank and rinse it thoroughly with clean cold water.
J)
Fill the tank with clean water up to the "MAX" level and insert it in
K)
its seat.
Start the cleaning mode pressing the espresso coff ee push button (5)
L)
and the long coff ee one (6) at the same time for 5 secs until the tank
is completely empty. If necessary, start the cleaning mode several
times (the machine features a safety system, which interrupts the
dispensing automatically after 100 operating seconds).
Carry out the operations described in point L).
M)
8. Maintenance
EN
53