To Clean The Product - Husqvarna FS7000 D Manuel D'utilisation

Maintenance
Replace the fuel filter.
Replace the radiator coolant.
Replace the air filters.
Do a check that the coolant mixture is correct. Refer to
Technical data on page 44 .

To clean the product

WARNING: Use protective glasses. When
you clean with a high-pressure washer, dirt
and harmful material can eject from the
product.
• Let the product become cool before you clean it.
• Make sure that the cover for the relay and fuse box
is correctly installed before you clean the product.
• Do not clean electrical components with water.
• Use a weak cleaning agent. Put on protective gloves
to prevent skin irritation.
• Use a high-pressure washer to clean the product.
To clean the radiator
CAUTION: Obey the instructions. Incorrect
procedure can cause damage to the cooling
fins.
• Use compressed air to clean the cooling fins.
• If it is necessary, use a high-pressure washer and a
weak cleaning agent.
• Spray directly on the radiator, in parallel to the
cooling fins.
• Keep a minimum distance of 40 cm/15.75 in.
between the cooling fins and the nozzle for the high-
pressure washer or air flow.
To clean the control panel
CAUTION: Do not use a high-pressure
washer to clean the control panel.
• Clean electrical components with a cloth or with
compressed air.
• Clean the control panel with a moist cloth.
To clean the engine
• Keep a minimum distance of 40 cm/15.75 in.
between the nozzle and the engine and engine
components.
1223 - 002 - 09.07.2019
Daily and
after
50 h 100 h
transpor-
tation
• Be careful when you clean the engine, especially
near electrical components. Do not spray water
directly at electrical components.
• Do not point the water directly into the exhaust pipe
or the engine air filter.
To do after you clean the product
• Blow electrical terminals dry with compressed air.
• Let the product become fully dry before you start the
engine.
To do a check of the radiator coolant
level
WARNING: Risk of burn injuries. Let the
engine become cool before you open the
radiator coolant lid.
1. Remove the radiator coolant lid.
2. Look down in the coolant tank. The coolant level is
correct when it is at the start of the tube in the
coolant tank.
3. If the radiator coolant level is too low, fill until the
level is correct. Refer to
for correct radiator coolant type and mixture.
To do a check of the engine oil level
To read the oil level correctly the product must be in the
correct position.
250 h 500 h Yearly
X
X
X
X
Technical data on page 44
29