Husqvarna FS7000 D Manuel D'utilisation page 31

1. Turn the water drain valve on the gearbox
counterclockwise to open.
2. Turn the water drain valve on the gearbox clockwise
to close.
To do a check of the water supply to
the cutting blade (FS7000 D)
1. Loosen the front bolt on the blade guard and lift the
blade guard latch (A).
C
2. Lift the blade guard front (B) and lock the blade
guard in upright position with a wire and carabiner
(C).
3. Open the water valve.
1223 - 002 - 09.07.2019
A
4. Make sure that the jets of water go straight out from
the holes and onto each side of the cutting blade.
5. Make sure that there are no leakages in the water
pipes.
B
6. Replace the water pipes if they are damaged.
To do a check of the water supply to
the cutting blade (FS7000 DL)
1. Lift the blade guard front.
2. Lock the blade guard in upright position with a spring
hook.
31