Husqvarna FS7000 D Manuel D'utilisation page 8

Reset button for the blade depth stop.
RESET
Reset button for the E-track adjustment
(optional).
This product complies with applicable EC
Directives.
Noise emission to the environment complies
with applicable EC Directives. The noise
emission of the product is specified in
Personal protective equipment on page 11
and on the label.
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
Symbols on the control panel display
E-track adjustment, left (optional).
E-track adjustment, right (optional).
Water safety system ON/OFF. The water
safety system monitors the water pressure
to the water cooling system for the cutting
blade. If the water pressure decreases, the
water safety system stops the cutting blade.
Engage/disengage blade clutch. This
function is not standard on all product
variants.
Blade depth stop.
Warning symbols on the control panel
display
Machine stop engaged. Reset the machine
stop button and cycle ignition.
The battery does not charge.
8
Low fuel level.
Preheating. Refer to the engine manual for
more information.
No water pressure to the water cooling
system for the cutting blade.
Low engine oil pressure.
Engine stop. The operation cannot continue.
Engine too hot. The operation cannot
continue. Refer to the engine manual for
more information.
Moderate engine problem. The operation
can continue.
Engine failure. Refer to the engine manual
for more information.
Regeneration is necessary. Refer to
Regeneration on page 38 . Only applicable
for products that comply with the Euro V
Emission standard.
Replace the diesel particulate filter (DPF).
Replace the diesel particulate filter
Refer to
on page 39 . Only applicable for products
that comply with the Euro V Emission
standard.
Error code not related to the engine.
Failure in the NOx Diagnostic Control
System. Only applicable for products that
comply with the Euro V Emission standard.
Water in the fuel.
1223 - 002 - 09.07.2019