Husqvarna FS7000 D Manuel D'utilisation page 16

To install a cutting blade
Product configuration for different
Read the section
blade dimensions on page 19 before you install a
cutting blade.
CAUTION: Risk of damage to the cutting
blade if it is installed opposite the direction
of rotation. Make sure that the cutting blade
rotates in the direction of the arrows shown
on the cutting blade.
1. Set the engine start switch to ignition on position (A).
A
2. Push the switch for cutting depth adjustment up to lift
the cutting blade.
3. Set the engine start switch to stop position (B).
4. Push the machine stop button on the control panel.
16
5. Close the water valve.
6. Open the blade guard:
a) Loosen the bolt or bolts on the blade guard and
lift the blade guard latch (A).
C
B
Note: Blade guards with dimension 20-42 in.
have 1 bolt. Blade guards with dimension 48-60
in. have 2 bolts.
b) Lift the blade guard front (B) and lock the blade
guard in upright position with the wire and
carabiner (C).
A
1223 - 002 - 09.07.2019
B