Operation; To Start The Product - Husqvarna WS 442 Manuel D'utilisation

1. Connect the water hose from the power pack to the
water inlet on the saw unit (A).
2. Connect the power cord from the power pack to the
saw unit (B).
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do a check of the work area before

operation

1. Examine the work area to make sure that safe
operation is possible. Look out for persons, objects
and situations that can prevent safe operation of the
product. Keep a safety distance of minimum 4 m.
2. Make sure that there are no electric cables, gas or
water pipes in the work area.
3. Make sure that the cut out piece can be removed.
Divide it into smaller sections to make it easier to
remove.
4. Keep the work area clean and bright.
5. Make sure that the work area has electric and water
supply. Make sure that waste water can be removed.
To do a function check before
operation
1. Do a check of the safety devices on the product.
Safety devices on the product on page 6 .
Refer to
2. Make sure that the blade and the blade guard are
not damaged. Replace the blade or the blade guard
if there are cracks or other damage.
3. Make sure that the product is correctly assembled
and that the wall brackets, rails, blade bolt and lock
wheels are tightened. Make sure that the end stops
are attached on the ends of the rail.
10
B
A
3. Start the power pack and start the remote control.
Make sure that the remote control is connected to
the power pack.
Operation
4. The blade guard must always be assembled when
the product is in operation. If the blade guard
touches the ceiling, 1 of the end pieces of the blade
guard can be temporarily disassembled.
5. Move the product to the start position before you
start the motor.
To select gear
• Select gear for the speed to use. On gear 1 the
speed range is 600-900 rpm and on gear 2 the
speed range is 800-1200 rpm. Refer to
Recommended blade speed on page 17 .

To start the product

1. Start the power pack and connect the remote
control. Refer to the Husqvarna power pack manual.
A
CAUTION: Make sure that the gear knob
is in the correct position. If the knob is
between gears it can cause damage to
the gearbox.
1094 - 002 - 26.09.2019
B