Checking The Impact Thrust; Final Checks; User Instruction - Erreka DOLFIN Manuel De L'utilisateur

4

CHECKING THE IMPACT THRUST

F < 400N in spaces between 50mm and 500mm
d
F < 1400N in > 500mm spaces
d
5

FINAL CHECKS

Following installation and programming, start up the
operator and check the devices installed.
1 Check the correct operation of the key devices (push
button and wall key, remote control).

See "Functioning modes" on page 50.
2 Check the correct operation of the safety devices
(photocells or mechanical strips).

See "A- Detection by photocell or strip" on
page 50.
3 Place an obstacle and make the gate collide with it
in order to check operation in the event of collision.

See "B- Direct detection (built-in safety)" on
page 50.

If the system does not work correctly, find out
why and put it right (see section "Failure
diagnosis" on page 65).
START UP AND PROGRAMMING
1 Measure the impact thrust and compare it to the
values indicated in Standard EN12453:2000. If the
values measured are higher than those in the
Standard, reduce the maximum thrust, the speed of
the gate, the slow down speed, or increase the slow
down distance.

Gate speed: A20X

Slowdown speed: A30X

Slowdown distance: A40X

Maximum thrust: A6XX

The control board must be programmed in a
manner which respects the values indicated in
standard EN 12453:2000, as shown in the
attached chart. The measurements must be
made in line with the method described in
standard EN 12445:2000.
• The standard indicates that at distances of
between 50mm and 500mm, the dynamic
force must be less than 400N. At distances of
over 500mm, the dynamic force must be less
than 1400N.

User instruction

1 Instruct the user with regards to the use and
maintenance of the installation and provide him/her
with the instructions on use.
2 Signpost the shutter gate, showing that it opens
automatically and indicating how to operate it
manually. Where appropriate,
operation is using the remote control.
indicate that
DOLFIN operator for sliding gates
63