Troubleshooting - Samsung BD-E5500 Manuel D'utilisation

Troubleshooting

Before requesting service, please try the following solutions.
PROBLEM
• Check the batteries in the remote control. They may need replacing.
No operation can be performed with
• Operate the remote control at a distance of no more than 6.1m
the remote control.
from the player.
• Remove the batteries and hold down one or more buttons for
several minutes to drain the microprocessor inside the remote
control to reset it. Reinstall the batteries and try to operate the
remote control again.
• Ensure that the disc is installed with the label side facing up.
The disc does not play.
• Check the region number of the Blu-ray Disc/DVD.
• Ensure that the disc has disc menus.
The disc Menu does not appear.
• This message appears when an invalid button is pressed.
The prohibition message appears on
• The Blu-ray Disc/DVD's software doesn't support the feature (e.g.,
the screen.
angles).
• You've requested a title or chapter number or search time that is
out of range.
• Some of the functions selected in the Setup Menu may not work
Play mode differs from the Setup Menu
selection. properly if the disc is not encoded with the corresponding function.
• The Screen Ratio is fixed on your Blu-ray Disc/DVD.
The screen ratio cannot be changed.
• This is not a problem with the player.
• Make sure you have selected the correct Digital Output in the Audio
No audio.
Options Menu.
The screen is blank.
SOLUTION
Forgot PIN
If you experience other problems.
The picture is noisy or distorted
No HDMI output.
Abnormal HDMI output screen.
PROBLEM
• If the HDMI output is set to a resolution your TV cannot support (for
example, 1080p), you may not see a picture on your TV.
• Press the p button (on front panel) for more than 5 seconds with
no disc inside. All settings will revert to the factory settings.
• When the factory default settings are restored, all stored user BD
data will be deleted.
• Press the p button (on front panel) for more than 5 seconds with
no disc inside. All settings including the password will revert to the
factory settings.
Don't use this unless absolutely necessary.
• When the factory default settings are restored, all stored user BD
data will be deleted.
• Go to the contents and find the section of the user manual that
contains the explanations regarding the current problem, and follow
the procedure once again.
• If the problem still cannot be solved, please contact your nearest
Samsung authorized service centre.
• Make sure that the disc is not dirty or scratched.
• Clean the disc.
• Check the connection between the TV and the HDMI jack of the
player.
• Check if your TV supports 576p/480p, 720p, 1080i or 1080p HDMI
input resolution.
• If random noise appears on the screen, it means that TV does not
support HDCP (High-bandwidth Digital Content Protection).
SOLUTION
|
33
English