Connections; Connecting To A Tv; Connecting To An Audio System; Method 1 Connecting To An Hdmi Supported Av Receiver - Samsung BD-E5500 Manuel D'utilisation

Connections

Connecting to a TV

Connect an HDMI cable (not supplied) from the HDMI OUT jack on the back of the product to
the HDMI IN jack on your TV.
- Do not connect the power cord to the wall outlet until you have made all the other
connections.
- When you change the connections, turn off all devices before you start.
| NOTE |
\ If you use an HDMI-to-DVI cable to connect to your display device, you must also connect the Digital Audio Out
on the player to an audio system to hear audio.
\ An HDMI cable outputs digital video and audio, so you don't need to connect an audio cable.
\ Depending on your TV, certain HDMI output resolutions may not work. Please refer to the user manual of your
TV.
\ When you connect the player to your TV using the HDMI cable or to a new TV, and then turn it on for the first
time, the player automatically sets the HDMI output resolution to the highest supported by the TV.
\ A long HDMI cable may cause screen noise. If this occurs, set HDMI Deep Colour to Off in the menu.
\ To view video in the HDMI 720p, 1080i, or 1080p output mode, you must use a High speed (category 2) HDMI
cable.
\ HDMI outputs only a pure digital signal to the TV.
If your TV does not support HDCP (High-bandwidth Digital Content Protection), random noise appears on the
screen.
|
12
English

Connecting to an Audio System

You can connect the Blu-ray player to an the audio system using one of the methods illustrated
below.
- Do not connect the power cord to the wall outlet until you have made all the other
connections.
- When you change the connections, turn off all devices before you start.

Method 1 Connecting to an HDMI supported AV receiver

• Connect an HDMI cable (not supplied) from the HDMI OUT jack on the back of the product
to the HDMI IN jack on your receiver.
• Best quality (Recommended)
Audio

Method 2 Connecting to an AV receiver with Dolby Digital or DTS decoder

Video
• Using a digital Coaxial cable (not supplied), connect the Coaxial Digital Audio Out jack on the
product to the Digital Coaxial In jack of the receiver.
• Good quality
• You will hear sound only through the front two speakers with Digital Output set to PCM.
Method 1 Method 2
Audio Audio