Publicité
Where:
PRESS OVER: indicates that the pressure measured is above the
maximum measurement threshold set (1000 mBar)
The unit of measurement of the pressure can be selected
(GAUGE menu→Unit) from "mBar","Pa","torr"
Pressing 4 times returns to the following screen page:
N
O
X
Where:
NORMAL: indicates the operating regime of the pump
XXXHz: see description "Pressing once" Measures key
The operating mode of the controller is shown at the bottom in
the center. This may be:
FRONT: front mode (the controller accepts START/STOP and
LOW SPEED commands from the front panel)
REMOTE: remote mode (the controller accepts START/STOP
and LOW SPEED commands via the rear connector)
RS232: the controller accepts commands from the serial port
according to the RS232 standard.
RS485 [XX]: the controller accepts commands from the serial
port in RS485 mode with address XX (XX from 0 to 31)
PROFIBUS [YYY]: the controller accepts commands from the
PROFIBUS port with address YYYY
TwisTorr 304 FS AG Rack Controller User Manual / 87-901-029-01
R
M
A
L
X
X
X
X
X
Technical Information
How to Use by Front Panel
X
X
X
X
X
X
X
17
X
X
H
z
X
X
X
253/301
Publicité
Chapitres
