How To Use By Front Panel - Aglient TwisTorr 304 FS AG Mode D'emploi

How to Use by Front Panel

Figure 30
Start Stop and Reset Fail button

The front panel START/STOP function is available only if the controller is set to
NOTE
"FRONT mode". If it is set to "REMOTE mode", when the key is pressed an error
message is shown indicating "COMMAND LOCKED IN REMOTE", if it is set to
"SERIAL" mode, the "COMMAND LOCKED IN SERIAL MODE" error message is
displayed. The "Reset Fail" function is always available regardless of controller
mode.
Low Speed

The front panel LOW SPEED function is available only if the controller is set to
NOTE
"FRONT"; otherwise an error message is returned. If it is set to "REMOTE"
mode, the COMMAND LOCKED IN REMOTE error message is displayed while if
it is in "SERIAL" mode the "COMMAND LOCKED IN SERIAL MODE" error
message is returned.
TwisTorr 304 FS AG Rack Controller User Manual / 87-901-029-01
AG
COUNTERS
increase
decrease
LOW SPEED
Press once for the START command and again for the STOP
command. In the case of controller's failure, press once to
reset the fail condition.
Press once to activate the LOW SPEED command; press
again to de-activate.

How to Use by Front Panel

LS R1
R2
VACUUM TECHNOLOGIES
MEASURES
next
menu
previous
START/STOP
TwisTorr 304 FS AG
Turbo-V 301-AG
Technical Information
249/301
17