Starting A Programme - AEG FSS6370XP Notice D'utilisation

40 www.aeg.com
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme

Starting a programme

1. Keep the appliance door ajar.
2. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode.
3. Press repeatedly
shows the number of the chosen
programme. The display shows the
programme number for
approximately 3 seconds and then
shows the programme duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
B
C
until the display
Starting a programme with
delay start
1. Set a programme.
2. Press
repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
The indicator is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is possible to
increase the delay time but not to
change the programme and options.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry
function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you
have to set the programme and options
again.
Press and hold Reset until the appliance
is in programme selection mode.
Cancelling the programme
Press and hold Reset until the appliance
is in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.