General Information; Technical Data; General Safety Regulations - Nussbaum TTC 500 Manuel D'instructions

The TTC 500 tyre changer has been specifically designed to demount and mount truck and bus tubeless tyres with rims from 14,5" to 24,5"
and a maximum 1400 mm diameter.
The optional accessories described in the paragraph concerned can also be used to work on wheels without the central hole, as well as those
with tubes.
Any other use is improper and therefore not authorised.
Before beginning any kind of work on or with this machine, carefully read and understand the contents of these operating instructions.
NUSSBAUM GmbH shall not be liable for any injury to persons or damage to property caused by improper use of this machine.
KEEP THIS MANUAL NEAR THE MACHINE AND CONSULT IT AS NEEDED DURING OPERATIONS.
Pump motor
Gear-box motor
Handles rim from - to
Max. wheel diameter
Max. wheel width
Max. wheel weight
Weight (with standard accessories)
Acoustic pressure level (at work)
Operators who work with this machine must be qualified and authorized.
To be considered qualified, an operator must understand the written instructions given by the manufacturer, be trained and be familiar with
the regulations governing labour safety.
Operators must not make use of drugs or alcohol which could alter their faculties.
It is, however, essential to:
- Know how to read and understand the descriptions.
- Know the performances and characteristics of this machine.
- Keep unauthorized persons away from the operating zone.
- Make sure that the installation has been made in compliance with all the pertinent regulations and standards in force.
- Make sure that all the operators have been sufficiently trained, that they know how to use the equipment in a correct and safe way and
that there is adequate supervision.
- Never touch the electrical equipment or power lines unless the power has been previously turned off.
- Carefully read this manual and learn how to correctly and safely use the machine.
- Always keep this manual ready to hand in an easily accessible place and consult it when necessary.
WARNING!
Unauthorized variations or modifications to the machine shall relieve the manufacturer from all liability for any
deriving damages or accidents.
In particular, removal or tampering with the safety devices represents a violation of the Labour Safety
regulations.
TTC 500

1. GENERAL INFORMATION

2. TECHNICAL DATA

3. GENERAL SAFETY REGULATIONS

14,5" - 24,5"
1400 mm (45")
695 mm (27")
LpA < 70 dB(A)
24
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
0,75 kW
0,75 kW
1200 kg
420 kg