Initializing This Unit - Sony HWS-BTA2W Mode D'emploi

Distorted sound
, Turn down the volume of the stereo audio
source device to the point where the sound is
no longer distorted. For details on volume
adjustment, refer to the operating instructions
supplied with the stereo audio source device.
, If the AUDIO IN jack of this unit is
connected to the LINE OUT jack of the
stereo audio source device, connect it to the
headphone jack.
Be sure to connect this unit to the headphone
jack of the stereo audio source device to be
connected. If this unit is connected to the
LINE OUT jack of the device to be
connected, sound may be distorted.
Cannot be connected to a
device that has been paired and
connected before.
, When using this unit as a transmitter, this
unit tries to connect with either of the last
two devices recognized before. If this unit
cannot make the BLUETOOTH connection
with a paired device, pair the device again, or
try making the BLUETOOTH connection
from the BLUETOOTH stereo audio
receiving device if possible.
, Pairing information may be deleted. Pair the
device again.
Common
Sound skips or the
correspondence distance is
short.
, If a device that generates electromagnetic
radiation, such as a wireless LAN, other
BLUETOOTH device(s), or a microwave
oven is nearby, move away from such
sources.
, Remove any obstacle between this unit and
other BLUETOOTH device or move away
from the obstacle.
, Locate this unit and other BLUETOOTH
device(s) as near as possible.
, Re-position this unit.
, Re-position other BLUETOOTH device.
Pairing cannot be done.
, Bring this unit and the BLUETOOTH device
closer together.
Sound is delayed.
, If you watch a TV or a DVD through
BLUETOOTH connection via this unit,
sound may lag behind the picture.
22
US

Initializing this unit

You can reset this unit to its default and
delete all pairing information.
1
If this unit is turned on, press
the 1 button to turn off this
unit.
2
While holding the 1 button,
press the ID SET button for 7
seconds or more.
The 1 indicator (green) and the
indicator (blue) flash four times, and
this unit is reset to the default setting.
All pairing information is deleted.