Transmitting - Sony HWS-BTA2W Mode D'emploi

Transmitting

Check the following before operating the unit.
– The TX/RX switch is set to "TX."
– The BLUETOOTH stereo audio receiving device's BLUETOOTH function is on.
– Pairing of this unit and the BLUETOOTH stereo audio receiving device is complete.
1
Press the 1 button to turn on this unit.
2
Prepare the BLUETOOTH stereo audio receiving device to be
connected within 5 minutes after turning on this unit.
This unit turns off 5 minutes after turning on without making the BLUETOOTH
connection. If this unit turns off before the BLUETOOTH connection is made, turn it on
again.
Note
When using this unit as a transmitter, this unit tries to connect with either of the last two devices
recognized before. If this unit cannot make the BLUETOOTH connection with a paired device, pair
the device again, or try making the BLUETOOTH connection from the BLUETOOTH stereo audio
receiving device if possible.
3
Start playing on the stereo audio source device connected to this
unit.
4
Adjust the volume of the stereo audio source device connected to
this unit.
Turn up the volume of the stereo audio source device as high as possible to the extent
that sound is not distorted.
Note
Turn off the bass boost function or equalizer function. If these functions are on, sound may be
distorted.
Note
In the following cases, you need to make the BLUETOOTH connection again.
– The power of this unit does not turn on.
– The power of the BLUETOOTH stereo audio receiving device does not turn on, or the BLUETOOTH
function is off.
– The BLUETOOTH function of this unit or the BLUETOOTH stereo audio receiving device is in sleep
mode.
– The BLUETOOTH connection is not made.
To finish transmitting
Terminate the BLUETOOTH connection by any of the operations below.
– Turn off this unit.
– Turn off the BLUETOOTH stereo audio receiving device.
17
US