Cleaning The Filters; General Care Instructions; Protect Against Freezing - GE GLDT690 Série Manuel Du Propriétaire

Caring for the dishwasher.
Cleaning the Spray Arms and the Filters (Continued)

Cleaning the Filters

For best performance and results, the filter assembly must
be cleaned once a month. The filter efficiently removes food
particles from the wash water, allowing water to be recirculated
during the cycle. For this reason, it is a good idea to remove the
large food particles trapped in the filter frequently by rinsing the

General Care Instructions

Two types of
air gaps
Check the air gap any time your
dishwasher isn't draining well.
12
STEP 1: Turn the filter counter-clockwise and lift up.
STEP 2: Lift the main filter up
STEP 3: Lift the fine filter up

Protect Against Freezing

If your dishwasher is left in an unheated
place during the winter, ask a service
technician to:
1
Cut off electrical power to the dishwasher.
Remove fuses or trip circuit breaker.
2
Turn off the water supply and
disconnect the water inlet line from
the water valve.
Does Your Dishwasher Have
an Air Gap?
An air gap protects your dishwasher against
water backing up into it if a drain clogs.
The air gap is not a part of the dishwasher.
It is not covered by your warranty. Not all
plumbing codes require
air gaps, so you may not have one.
main filter and cup under running water. To remove the filter
assembly, follow the 3 steps shown below. To clean the main
filter and fine filter, use a cleaning brush. The dishwasher must
never be used without the filters. Improper replacement of the
filter may reduce the performance level of the appliance and
may damage dishes and utensils.
3
Drain water from the water inlet line
and water valve. (Use a pan to catch
the water.)
4
Reconnect the water inlet line to the
water valve.
The air gap is easy to clean.
1
Turn off the dishwasher and lift off the
chrome cover.
2
Remove the plastic cap and clean with
a toothpick.