Setting The Remote Control - attika PILAR Notice D'installation

SETTING THE REMOTE CONTROL

The remote control can be set to display the time, temperature, etc.
To enter the manual setting menu, press the 'up' button and 'down' button at the same time for about five seconds, until the
display changes.
NB:
To change the setting, press the 'up' button (the button on the right) will change the setting.
•
To move to the next menu, press the 'down' button (the button on the left).
•
Move to the next menu within 15 seconds.
•
After 15 seconds of inactivity, the programming menu will be exited.
•
Settings are saved automatically.
•
Menu 1:
Select whether you want to display the temperature in degrees Fahrenheit
or degrees Celsius.
The figure states the room temperature.
Menu 2:
Select whether you want to display the time in 24-hour or 12-hour format.
GB - 23