Removing The Combustion Chamber Lining - attika PILAR Notice D'installation

REMOVING THE COMBUSTION CHAMBER LINING

REMOVING THE COMBUSTION CHAMBER LINING
Procedure to remove the combustion chamber lining:
1. P ush the flue plate (1) up until it becomes free of the fitting. It
can now be pulled forward and down past the fitting.
2. L ift up the front combustion chamber lining (2) and remove.
3. Lift up the bottom combustion chamber lining (3).
4. R emove the side combustion chamber lining (4) by turning
them inwards at the front until they become loose. They can
now be removed.
5. F inally, remove the rear combustion chamber lining (5).
the combustion chamber lining, repeat the
When it is time to re-fit
above procedure in reverse order.
A
A
1
5
4
4
2
2
2
INDUSTRIVEJ 20, 9900 FREDERIKSHAVN, DENMARK
Phone +45 98 47 90 33 - Fax +45 98 47 92 91
E-mail: info@rais.dk - Homepage: www.rais.dk
Drawing name:
Project: Established: Format:
24-05-2019
A3
3 3
Designer: Project manager: Approved:
ksj
D M Y
Corrections:
Revision: Drawing no.:
16-6510
GB - 15