Bosch NGM5055 Manuel page 11

Placing Burner Caps
Each cap has a letter (A, D, or F) cast in the underside of
the cap that corresponds to a letter (A, D, or F) cast in the
burner base that is attached to the appliance.
Burner Base
Checking Burner Cap Placement
• Check to make sure there is not gap between the
burner cap and burner base. See figure "Burner Cap
• Place each burner cap on its correct burner base per
its corresponding letter designation. See figure
"Burners Caps" on page 8.
• Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
Burner Cap
Matching letter
designation.
Placement" on page 9 to see the correct and incorrect
placements of the burner cap.
• You may gently try to move the burner cap from side to
side to check if it is properly placed. If properly placed,
Figure 4: Burners Caps
English 8