Package Contents; Electrical Safety; Assembly And Adjustments - DeWalt DW677 Traduction De La Notice D'instructions Originale

Package Contents

The package contains:
1 Planer
1 Parallel fence
1 Spanner
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. On/off switch
b. Lock-off button
c. Shavings discharge outlet
d. Planing depth adjustment knob/front handle
e. Planing depth graduation
f. Wing bolt for parallel fence
g. Hole for parallel fence
h. Side guard
i. Motor cover
j. Drive belt cover
k. Parking shoe
r. Main handle
INTENDED USE
Your planer has been designed for professional
planing of wood.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These planers are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power
input of this tool (see technical data).The minimum
conductor size is 1.5 mm 2 ; the maximum length is
30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Adjusting the Depth Of Cut (fi g. 3)
Turn the planing depth adjustment knob (d) to the
required depth of cut.
One graduation corresponds to a depth of cut of
0.1 mm.
EN G LI SH
21