EUFAB 17478 Mode D'emploi page 3

Smartphone bracket with USB connection
1. INTENDED PURPOSE
This Smartphone bracket with USB connection is used to attach a mobile telephone to the cigarette lighter socket in a vehicle in order
to charge the battery.
2. SPECIFICATIONS
Description: Smartphone bracket with USB connection
Input voltage: 12/24 V DC
3. SAFETY NOTES
Keep away from children and do not allow children to operate this device!
Only use this product for the purpose for which it is intended!
Do not manipulate, open or disassemble the device!
For your own safety only use accessories or replacement parts specified in the instruction manual or those that are recommended by
the manufacturer!
Ensure that the installed Smartphone bracket with USB connection does not hinder you in the driving of your vehicle
4. OPERATING INSTRUCTIONS
WARNING
Read the operating instructions through carefully prior to initial use and observe all of the safety notes! Not
observing such may lead to personal injury, damages to the device or your property! Prior to initial use check the
contents of the packaging to ensure that they are in perfect condition and complete! Store the original packag-
ing, the receipt and these instructions so that
they may be consulted at a later date! When transferring the ownership of the device, pass on the operating
instructions as well.
Installation:
Insert the ball head of the connector through the nut and engage it with the ball pan of the bracket. Screw the nut to the thread of the
ball pan. Now plug the connector firmly into the 12 V socket of your vehicle.
When the control LED lights up, the device is ready for use.
Using the Smartphone:
Press the "PUSH" surface and slide the holding clip upwards. Connect the charging cable to your mobile telephone and insert it in the
lower brackets. Then slide the upper holding clip so far back that the device is
securely attached. Gently loosen the nut of the ball joint, set the bracket to the optimum viewing angle and tighten the nut back up
again. Connect the charging cable with the USB connection of the Smartphone bracket.
Removing the Smartphone:
Press the upper holding clip gently upwards and tip the phone forwards. After parking the vehicle, remove the connector from the 12 V
socket because otherwise you will discharge the battery of your vehicle.
Replacing the fuse:
Rotate the knurled screw at the tip of the 12 V connector in an anticlockwise direction until it comes away from the connector and
remove. The fuse (1.5 A, 250 V) is released and can be removed from the connector. Replace the fuse with a new one of the same type
and screw the knurled screw back into the connector.
5. MAINTENANCE
The Smartphone bracket with USB connection does not require maintenance if used according to the intended purpose. Clean the device
with a soft, dry cloth only. Store the device in a dry place.
6. NOTES REGARDING ENVIRONMENTAL PROTECTION
Electrical devices may not be disposed of in the ordinary household waste. Please dispose of this device via the public,
community collection points. The materials can be recycled as shown by the labelling. The recycling, material reuse or other
forms of reuse of old devices makes a important contribution towards the protection of our environment!
7. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Output voltage: 5 V DC
Maximum current: 1,5 A
info@eal-vertrieb.com
www.eal-vertrieb.com
.
3