J5 - Gauge Connector - Agilent Technologies TwisTorr 74 FS AG Mode D'emploi

J5 – Gauge Connector
This connector is used to connect to active gauges with its extension
cable (see orderable parts table). The pressure can be read via serial
line (WIN. 224) or by REMOTE I/O on Programmable Analog Out (in
this case, the controller replicates the signal coming from the gauge).
Figure 13
TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01
GAUGE
+25VDC P MAX 2W
SIGNAL
J5 Gauge Connector
Technical Information
J5 – Gauge Connector
J5
IDENTIFICATION
SIGNAL COMMON
COMMON
17
159/192