Faults - What To Do; Appliance; Dispenser - Thermador T18ID900RP Guide D'utilisation Et D'entretien

3 Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the fault yourself.
d o ? F a u l t s – w h a t t o

Appliance

Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
The refrigeration unit is switching on more frequently and for longer.
The appliance was opened frequently.
The ventilation openings are covered up.
Large quantities of fresh food have been put in.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------

Dispenser

Ice is being produced and dispensed but no water.
Fault with the appliance.
Ice and water dispenser not working.
Controls for ice and water dispenser panel lock are locked (child
lock).
Ice cubes may freeze together and block the dispenser or the ice
maker.
After switching on or removing many ice cubes, there will be too few
in the ice cube container.
Water tank is filling up.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 14
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Do not open the appliance unnecessarily.
Remove obstacles.
Switch on Super Freeze in good time.
Start the appliance self-test.
~ "Appliance self-test" on page 25
When the program has ended, the appliance switches over to normal
operation.
Call customer service.
~ "Customer service" on page 25
Unlock ice and water dispenser panel lock.
Open the door. Check inside whether ice cubes are stuck in the ice
1.
and water dispenser.
If the ice and water dispenser is not blocked, carefully pull the ice
2.
cube container out.
CAUTION!
A full ice cube container is heavy! Use both hands and proceed
slowly.
Remove the ice cubes which are frozen together.
3.
It takes around 24 hours for an empty ice cube container to fill up.
When used for the first time, the water tank takes around 2 hours to
fill up.
Faults – what to do? en-us
23