Ice And Water Dispenser; Before Using For The First Time; Observing Drinking Water Quality; Information On Operation Of The Ice Maker - Thermador T18ID900RP Guide D'utilisation Et D'entretien

en-us Ice and water dispenser

;Ice and water dispenser

You can use the ice and water dispenser to
p e n s e r I c e a n d w a t e r d i s
dispense:
cooled water
■
crushed ice
■
ice cubes
■

Before using for the first time

9
WARNING
RISK OF INJURY!
Never reach into the dispenser opening of the
ice cube container.
9
CAUTION!
Do not place bottles or food in the ice cube
container. This can block and damage the ice
maker.
Notes
The ice and water dispenser only works when the
■
appliance is connected to a drinking water
pipeline.
Dispose of the first 5 glasses of water and the
■
first 30-40 ice cubes for hygienic reasons
When the appliance has been connected, there may
be air in the water circuit. Keep dispensing water
until there are no more air bubbles in it.
It takes approx. 24 hours until the first serving of ice
cubes is ready.

Observing drinking water quality

All materials used in the ice and water dispenser are
odorless and tasteless.
If the water has an aftertaste, this may be due to the
following causes:
Mineral content and chlorine content of the
■
drinking water
Material of the water pipeline
■
Freshness of the drinking water.
■
Note: If you dispense water again after a long time, it
may taste stale. In this case, dispose of the first 15
glasses.
You will obtain the best water quality if you dispense
a little water regularly.
The supplied water filter will filter only particles out of
the water, not bacteria or microbes.
20

Information on operation of the ice maker

Ice cube production starts as soon as the freezer
compartment has reached the set temperature.
The ready ice cubes are automatically discharged
into the ice cube container.
Ice cube production stops as soon as the ice cube
container is full.
Note: You can accelerate ice production by setting a
colder freezer compartment temperature. This will
slightly increase energy consumption.

Dispensing ice and water

Notes
To prevent ice from falling on the floor, hold the
■
glass directly under the dispenser when
dispensing crushed ice.
To prevent water damage, the water dispenser
■
automatically stops after 30 seconds of
continuous dispensing. If you want to dispense
more water, wait 5 seconds and press the button
again.
The dispensed water is cooled to a palatable
■
temperature. To obtain a colder drinking
temperature, put more ice cubes in the glass.
The water may become warmer when dispensing
■
fairly large amounts of water.
Hold the glass under the ice and water dispenser.
1.
Keep pressing the dispensing button until the
2.
required quantity of ice or water is in the glass.