Using The Glasstron - Sony Glasstron PLM-A55 Mode D'emploi

Using the Glasstron

You need to set a password the first time you use the Glasstron or after you reset the Glasstron.
Set the password following the procedure in "Setting the password" (pages 23 and 24).
Before you start...
Be sure to follow the procedures in "Connecting the Glasstron" (page 14) and "Wearing the
Glasstron" (page 16).
1
Turn on the Glasstron using the POWER switch, then press the
SEL/PUSH EXEC jog dial.
Change the display language before pressing the jog dial, if necessary.
If you have set the Glasstron to operate without a password, go to step 3.
2
Turn the jog dial to enter the first number of your password, then
press the jog dial. Enter the second and third numbers in the
same way.
If you enter a wrong password, the
message shown on the right appears.
Enter the correct password.
If you have entered a wrong password
more than five times, after about ten
seconds, the Glasstron turns off
automatically.
POWER
ON / OFF
PUSH DISPLAY
SEL / PUSH EXEC
Screen
DISPLAY LANGUAGE
ENGLISH
FRANÇAIS
SEL EXEC
ENTER THE THIRD NUMBER
OF YOUR PASSWORD.
123
SEL EXEC
Entered password
INCORRECT PASSWORD.
ENTER THE FIRST NUMBER
AGAIN.
122
Wrong password
INCORRECT PASSWORD.
SEE THE USER'S MANUAL.
continued
25
-US