Using The Optional Battery Pack; Charging The Battery Pack - Sony Glasstron PLM-A55 Mode D'emploi

Using the optional battery pack

If you use a battery pack such as the NP-F550/F750/F950, you can use the Glasstron without
connecting to a wall outlet.

Charging the battery pack

Charge the battery pack before use. You can charge the battery pack using the power supply
box. If you attach the battery pack as described below, the battery pack charges while you are
not using the Glasstron.
1
Attach the battery pack to the power supply box.
Install the battery pack properly making
sure it is not crooked against the power
supply box.
To remove the battery pack, while
sliding BATT RELEASE, pull out the
battery pack.
2
Connect the AC power adapter to the DC IN connector on the
power supply box. Then, connect the AC power cord to the AC
power adapter and to a wall outlet.
Charge the battery pack on a flat place
without vibration. The CHARGE lamp
lights up. When the battery pack is fully
charged, the CHARGE lamp goes out.
Battery life and charging time are shown
in the table below.
Battery life (fully charged battery)
NP-F550 Approx. 2 hours 20 minutes
NP-F750 Approx. 4 hours 40 minutes
NP-F950 Approx. 6 hours
* The battery life and charging time may change depending on the conditions of use.
* You can also use a battery pack such as the NP-F530/F730/F930 (not supplied) with the Glasstron.
* You can use an "InfoLITHIUM ™ " battery pack with the Glasstron. When using such a battery pack,
the estimated remaining battery life is displayed not with the time counter but with the indicator.
32
-US
Power supply box
BATT RELEASE button
CHARGE lamp
Battery pack
AC power cord
to wall outlet
AC power
adapter
to DC IN
Charging time
Approx. 8 hours
Approx. 16 hours
Approx. 24 hours