Regular Checks; Revisions - Wayscral EVERYWAY E-300 Notice D'utilisation

III.

Regular checks

Concerning the tightening of the bolts: lever, crank, pedals, brackets.
The tightening torques to apply are as follows:
COMPONENTS
Pedals on crank arms
Crank arm on bottom bracket
Steering tightness
Tilt stem
Headset tightening
Brake lever
Brake callipers
Seat
Seat post clamp
Wheel
The other tightening torques depend on the nut sizes: M4: 2.5 to 4.0 N.m., M5: 4.0 to 6.0 N.m., M6:
6.0 to 7.5 N.m. Tighten the bolts according to the required torque.
Regularly check the tyres and the tread of the rear wheel: wear, cuts, cracks, pinching. Replace the tyre
if necessary. Check the wheel rims for excessive wear, warping, denting, cracks...
IV.

Revisions

For safety reasons and to maintain the components in a good state, you should have your bicycle
revised periodically by your distributor. Your bicycle should also undergo regular maintenance by a
qualified technician.
First revision: 1 month or 150 km
•
Check the components are well-tightened: crank arm, wheel, stem, pedals, handlebars, seat
clamp,
•
Check the power-assistance system is working correctly,
•
Check and adjust the brakes,
•
Tighten and/or straighten the wheels.
Every year or 2000 km:
•
Check the wear levels (brake pads, gear system, tyres),
•
Check the power-assistance system is working correctly,
•
Check the bearings (bottom bracket, wheels, steering, pedals),
•
Check the cables (brakes, derailleur),
•
Check the lighting,
•
Tighten and/or straighten the wheels.
RECOMMENDED TORQUE
30 - 40
30 - 40
14 - 15
6 - 8
6 - 8
18 - 20
30
49
SPECIFIC GUIDELINES
Lubricate the threads
Lubricate the threads
Automatic tightening
Automatic tightening
Immersion screw (stem)
Quick clamp