Work At Electrical Components; Setup On An Uneven Surface; General View Of Application; Application - WAGNER SUPER FINISH 23 CR Mode D'emploi

GB
SAFETY REGULATIONS
1.19

WORK AT ELECTRICAL COMPONENTS

Unplug the power plug from the outlet before carrying out
any repair work.
1.20

SETUP ON AN UNEVEN SURFACE

The front end must always point downwards in order to avoid
sliding away.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
2

GENERAL VIEW OF APPLICATION

2.1

APPLICATION

Super Finish 23 CR is an electric driven unit for the airless at-
omization of different painting materials. The Super Finish 23
CR is also great for processing injection foams and injection
resin.
Super Finish 23 CR is made for jobs in the workshop and on
the building site.
The unit performance is conceived so that its use is possible
on building sites for small- to middle-area dispersion work.
When painting, the device is suitable for all kinds of typical
painting jobs, e.g.:
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.
We recommend using the top container for paintwork.
32
2.2

COATING MATERIAL

Diluting lacquers and paints or those containing solvents, two-
component coating materials, dispersion and latex paints.
Injection foams (one and two-component)
Injection resin (one and two-component)
No other materials should be used for spray-
ing without WAGNER's approval.
Pay attention to the Airless quality of the
coating materials to be processed.
The unit is able to process coating materials with up to
20,000 mPas. If highly viscous coating materials cannot be tak-
en in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instructions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spray-
ing and can, in fact, lead to interruption of
operation.
2.2.1
COATING MATERIALS WITH SHARP-EDGED
ADDITIONAL MATERIALS
These particles have a strong wear and tear effect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
2.2.2
FILTERING (FOR SPRAY WORK)
Sufficient filtering is required for fault-free operation. To this
purpose the unit is equipped with a suction filter and an inser-
tion filter in the spray gun. Regular inspection of these filters
for damage or soiling is urgently recommended.
Super Finish 23 CR