Step 5: Electrical Requirements, Connection And Grounding - Thermador PCG304G Manuel D'installation

Step 5: Electrical Requirements, Connection and Grounding

MODEL
TYPE
30"
36"
36" with griddle
36" with grill
48" with griddle
48" with grill
• Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally. Always disconnect appliance from the
electric supply either by disconnecting power cord or
shutting off the breaker at the service panel before
servicing the appliance.
WARNING!
ELECTRICAL SHOCK HAZARD
To avoid the risk of electrical shock, personal
injury or death; verify electrical power is
turned off at the service panel and gas supply
is turned off until the rangetop is installed and
ready to operate.
• Before you plug in an electrical cord, be sure all
controls are in the OFF position.
• All 120 Volt rangetop models must be plugged into a
mating 3-Prong, Grounding-Type Receptacle. The
receptacle must be connected to a properly dedicated
grounded and polarized electrical power supply rated
at 120VAC, Single Phase, 60HZ (see Figure 11).
CAUTION!
Improper grounding or reverse polarization will cause
malfunction (such as continuous sparking of the burner
igniters). This can damage the appliance and can create
a condition of shock hazard. If the dedicated circuit is not
correctly grounded and polarized, it is the responsibility
and obligation of the installer and user to have the
existing receptacle changed to a properly dedicated
grounded and polarized receptacle. This must be
accomplished in accordance with all applicable local
codes and ordinances by a qualified electrician. In the
absence of local codes and ordinances, the receptacle
replacement shall be in accordance with the National
Electric Code. (See Figure 11.)
VOLTAGE
120 VAC
120 VAC
120 VAC
120 VAC
120 VAC
120 VAC
CIRCUIT
FREQUENCY
RATING
10 Amps
10 Amps
15 Amps
15 Amps
15 Amps
15 Amps
Table 1: Electrical Supply Circuit Requirements
• Observe all governing codes and ordinances when
grounding. In the absence of these codes or
ordinances observe National Electrical Code ANSI/
NFPA No. 70 current issue. See Figure 11 for
recommended grounding method.
• Power cord and receptacle should protrude no more
than 2" (51 mm) from the rear wall.
• An electrical wiring diagram and schematic have been
attached to the back of the rangetop chassis for access
by a qualified service technician. Do not remove or
discard this important information.
• Installer - show the owner the location of the circuit
breaker. Mark it for easy reference.
Grounding Method
The rangetop is factory equipped with a power supply cord
with a three-prong grounding plug (with polarized parallel
blades).
Figure 11: Recommended Grounding Method for 120V
PHASE
60 Hz. Single
60 Hz. Single
60 Hz. Single
60 Hz. Single
60 Hz. Single
60 Hz. Single
English 11
Models