Table des Matières
Publicité
IR REMOTE CONTROL / IR FERNBEDIENUNG / TÉLÉCOMMANDE INFRAROUGE / MANDO A
DISTANCIA POR INFRARROJOS / PILOT NA PODCZERWIEŃ / TELECOMANDO A INFRAROSSI
EN
Point the infrared remote control directly at the infrared sensor installed on the front of the spotlight. The maximum range is
about 8 metres. If the beam effect is operated in the DMX or Slave modes, the functions on the remote control are disabled.
Press the blackout button to activate the sleep mode on the beam effect (the effect LED is off, the display will show
Black
On/Off
Out
"OFF"). Press the blackout button again to return to the previously activated operating mode.
The colour change programs Pr00 to Pr10 can be activated by pressing the AUTO button (Pr00). Now you can directly
Auto-
select the programs Pr01 to Pr10 using buttons 1 to 0. The Jump button
Auto
Program
to Pr12 by scrolling up through the numbers; the Fade button
(fading programs). The program running speed can be adjusted using the
The Music control programs Pr00 to Pr12 can be activated by pressing the Sound button (Pr00). By repeatedly pressing the
Music
Sound button, you can select the programs Pr00 to Pr12 by scrolling up through the numbers; the Programs Pr00 to pr09
Sound
Control
can be directly activated using buttons 0 to 9. To adjust the sensitivity with which the beam effect responds to sounds
(bass pulses), press the
To activate the DMX mode, press the DMX button; the DMX address can be set as desired using the
DMX
DMX
(A001 - A512). If you press the DMX button again, the DMX address can also be set using the
Control
CH03, CH04, CH06, please follow the display).
Red
Green
Repeatedly press the Colour button, if necessary, to activate the desired colour LEDs (only 1 colour possible). You can also
Static
activate a strobe effect by pressing the Flash button
Color
colours
using the
The numeric buttons 0 to 9 are used to directly select the program in the Auto program and Music control operating
modes.
The plus and minus buttons allow you to adjust the program speed, microphone sensitivity, stroboscope frequency, as well
+
-
as the DMX address and the DMX mode in the corresponding operating mode.
20
and
+
Static
Blue
Amber
colours
and
buttons. Pressing the Flash button again stops the strobe effect.
+
-
Fade
buttons in eight increments.
-
Press one of the colour buttons to activate the corresponding LEDs (only 1 colour
possible). You can also activate a strobe effect by pressing the Flash button
adjust the strobe frequency from slow to fast in 4 increments using the
buttons. Pressing the Flash button again stops the strobe effect.
and adjust the strobe frequency from slow to fast in 4 increments
Flash
allows you to select the Auto Programs Pr01
Jump
is used to select the Auto Programs Pr13, Pr14 and Pr15
and
buttons in eight increments.
-
+
+
and
buttons
+
-
and
buttons (CH02,
-
and
Flash
+
and
-
Publicité
Table des Matières
