Assembly; Packing List - Ryobi 18 VOLT ONE+ Série Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.

PACKING LIST

Blower
Blower Tube
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.

ASSEMBLY

Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
ASSEMBLING THE BLOWER TUBE
See Figure 2.
 With the logo area facing up, slide the blower tube over
the outlet on the blower housing.
 Press down on the tab on the blower housing outlet.
 Push tube on the blower housing outlet until tab
locks into place through the slot in the blower tube.
 To remove the blower tube, push tab down and slide tube
off.
6 — English
WARNING:
WARNING: