EIBENSTOCK EMF 150.1 Notice Originale page 24

Dust Extraction
Dust which occurs during your work is hazardous to health. That is
why the EMF 150.1 must be used with a vacuum cleaner, and a dust
mask has to be worn.
The suitable Wet/Dry Vacuum Cleaner DSS 35 M iP is available as
accessory. It can directly be attached to the connection on the dust hood.
Fig.6
Abb.7
Abb.8
When insert the suction hose
pull the ring of the hose fixing and turn the nozzle till the fixation engages.
Overload Protection
In order to protect the operator, motor and tool, the wall chaser is equipped
with an electronic and thermal overload protection.
Electronic: To warn the user against an overload of the machine due to
too high contact pressure, a LED is attached to the switch
grip. It does not light during idle run or at normal load.
When the unit is overloaded the LED lights red, in this
case, the unit must be stress-relieved. You can continue
The suction hose can be locked
against slipping out by means of the
hose fixing.
Make the necessary drill hole as follows:
Put the suction hose in the connector of
the hood.
Mark the plug-in depth with a crayon.
(see arrow)
Drill 13 mm from this marking (line) a hole
with diameter 6 mm in the nozzle.
24