EIBENSTOCK EMF 150.1 Notice Originale page 23

Press the spindle lock button to lock the work spindle (see arrow – Fig.4).
Screw on the clamping screw and tighten it with the face spanner (see
Fig.5).
Instructions for assembly:
Regardless of the requested grove width, all spacer discs
•
provided must always be mounted.
Otherwise, the diamond cutting disc can become loose during
operation and lead to injuries.
At least one spacer disc must be mounted between two diamond
•
cutting discs.
When mounting the diamond cutting discs, ensure that the
•
direction of rotation arrows on the diamond cutting disc match
with the rotation direction of the machine (see direction of
rotation arrow on the protective hood).
Always replace the diamond cutting discs in pairs.
•
Use only original accessory!
•
The wall chaser is in power and speed optimal adjusted to the
•
EIBENSTOCK-diamond cutting discs.
Thus you reach the best work result in consideration of the
•
material to be worked on (see accessories).
In order to check whether the spindle stop is released before you
switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
Information on Structural Calculations
Slots in supporting walls are subject to the Standard DIN 1053 part 1, or
country- specific regulations.
These regulations are to be observed under all circumstances.
Before starting work, consult the responsible structural engineer, architect or
the construction supervisor.
The permitted slot depth and width depends on the slot length, wall
thickness and the building material used.
23