Pelvic Restraint Belt - Quickie Xenon2 FF Notice D'utilisation

6.15 Pelvic Restraint Belt

WARNINGS!
• Before using the wheelchair make sure that the pelvic
restraint belt is fitted.
• The pelvic restraint belt must be checked on a daily
basis to ensure it is free from any obstruction or
adverse wear.
• Always make sure that the pelvic restraint belt is
correctly secured and adjusted prior to use.
DANGER!
If the strap is too loose, this could cause the user of the
wheelchair to slip down and risk suffocation or serious
injury.
The pelvic restraint belt is fitted to the wheelchair as
shown in Fig.6.15.1 to Fig.6.15.10. The seat belt
comprises two halves. They are fitted using the existing
seat stay retaining bolt fitted through the eyelet on the
belt. The belt is routed under the rear of the side panel.
(Fig.6.15.1).
Adjust the pelvic restraint belt to suit the user's needs as
follows:
Adjust the belt position so buckles are in the centre of the
seat. (Fig.6.15.2).
Feed free belt back through male buckle and slide
adjusters.
Ensure belt is not looped at male buckle, (Fig.6.15.3).
Feed free belt through slide adjusters and male buckle to
provide more belt length, (Fig.6.15.4 to Fig.6.15.6).
Fig.6.15.1
XENON 2 FF
Fig.6.15.2
Fig.6.15.3
Fig.6.15.4
Fig.6.15.5
Fig.6.15.6
30 Rev.4.0