Noise/Vibration Information; Mounting And Operation - Bosch GBH Professional 2-24 D Notice Originale

OBJ_BUCH-1426-004.book Page 12 Monday, December 2, 2013 12:45 PM
12 | English
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9
D-70745 Leinfelden-Echterdingen
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 08.05.2013

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 183.

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Selecting a drill chuck
(GBH 2-24 DF)
Removing the Quick Change Chuck
(GBH 2-24 DF)
Inserting the Quick Change Chuck
(GBH 2-24 DF)
Inserting SDS-plus Drilling Tools
Removing SDS-plus Drilling Tools
Inserting the Key Type Drill Chuck
(GBH 2-24 DF)
1 619 92A 06J | (2.12.13)
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may signif-
icantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
4
5
6
Page
184
185
185
185
186
186
Bosch Power Tools