Connecting A Chimney Or Open Furnace To The Flue - Nordica FULVIA Instructions Pour L'installation, L'utilisation Et L'entretien

In presence of dampness in the room where the stove has been placed, we advise you to put absorbent
salts into the hearth.
If you want to keep for long the aesthetic look of the cooker it is important to protect its internal walls in row
cast iron with neutral Vaseline.

15. CONNECTING A CHIMNEY OR OPEN FURNACE TO THE FLUE

The smoke channel is the section of tube that connects the product to the flue, in the connection these
simple but very important principles must be
followed:
•
for no reason must the smoke channel be
used with a diameter lower than that of the
neck of the outlet with which the product is
fitted;
•
each metre of horizontal route of the
smoke channel causes a small leak of
charge which should be compensated for
by raising the flue;
•
the horizontal section must never be higher
than 2 m (UNI 10683-2005);
•
each bend of
considerably reduces the draught of the
flue which must be compensated for by
raising it suitably;
•
the UNI 10683-2005 Regulation – Italy
requires that the bends or variations of
direction must in no case be greater than 2
including the emission into the flue.
Wanting to use the flue of a chimney or open
furnace, it will be necessary to close the hood
hermetically below the inlet point of the smoke
channel pos. A Picture 9.
If the flue is too large (e.g. cm 30x40 or 40x50)
it is necessary to duct it with a stainless steel
tube of at least 200 mm of diameter, pos. B
taking care to close the space between the
tube itself and the flue immediately below the
chimney cap pos. C.
26
the smoke channel
For further information please contact your Dealer.
FULVIA – GAIA
C - Plugging
B
A – Hermetic closure
Inspection
hatch
Picture 9
7191010 – EN